The Magnetic Pulser-Model MP5 - The Magnetic Pulser is a professionally designed quality magnetic induction device, thoroughly tested and guaranteed to operate as per the specifications. The Magnetic Pulser offers the benefits of a pulsed magnetic field to help balance the body’s natural electricity for greater well-being. The Hand Paddle can be applied anywhere on the body. This unit has a built-in timer for 20-minute sessions.
All our Magnetic Pulsers have either the North pole clearly marked, or on previous models North is always on the flat face of the coil - the side normally used against the body. North is to be described as South-Seeking.
What is "The Magnetic Pulser"?

The Magnetic Pulser (MP) is designed to generate an intense (~6,000 Gauss*), momentary (~2.5mS) pulsed DC magnetic field. *Magnetic flux intensity follows the inverse square rule - the further you are away from the magnetic core, the faster the Gauss intensity drops off. At face of Magnetic Coil, the Gauss is ~6,000 Gauss. NOTE: Please do not confuse this unit with permanent/ceramic magnet therapies, or with the EMR (electro-magnetic radiation) producing units!

Options for Powering the Magnetic Pulser In the event of a power outage here are some options for powering the Magnetic Pulser:

1. The Magnetic Pulser may be operated directly from a 12 Volt DC Battery like an automobile cigarette lighter. You will need to purchase an Adapter cord which plugs into the cigarette lighter and has a Centre Positive, 2.1mm Plug, like from Radio Shack®.

2. The Magnetic Pulser can be powered by a suitable solar panel. Keep in mind that most solar panel generators are used to re-charge a battery which in turn operates the unit. Therefore we suggest you use a solar panel (preferably a sealed Gel-Cel® type) to re-charge a 12 Volt DC automobile battery, then run the Magnetic Pulser directly from the battery. You will need to use a cord which has alligator clips on one end to attach to the battery terminals, and the appropriate Centre Positive, 2.1mm Plug on the other end to plug into the Magnetic Pulser. Be careful with polarity! This type of cord with alligator clips on one end is probably not readily available, therefore you will to need to buy a cord and cut off the end that normally goes into the cigarette lighter, and solder your own set of alligator clips. Use a black and red alligator clips so you ensure polarity is correct each time you connect the circuit.

3. If you wish to operate the Magnetic Pulser directly from a solar panel you will need to use a 12 Volt DC output panel that is capable of supplying at least 2.5 Amps. The Magnetic Pulser's initial starting demands may require a higher output solar panel. That is why it is preferable to use a charged 12 Volt DC battery instead.